This directory contains:
  - A SOF to configure your FPGA for flash programming.
  - A shell script to that automates the programming.
  - An srecs sub-directory with everything to be programmed in your flash.

Just run the shell script, without options, in order to see how to use it.

If you're programming your board, for the first time, you'll want to:
1.  Press the "Factory Config" button when completed.
2.  Type "nios2-terminal" to enter a U-Boot terminal session.
3.  Type "autoscr 0xc3ff0000" to set your initial U-Boot environment properly.
  - NOTE:  See the Getting Started Guide for more information on what U-Boot
    provides.
